Kingston Hyper X Blu KHX1600C9D3B1/4G 4Gb DDR3 1600Mhz RAM Module

Product Specifications

Kingston Hyper-X Blu KHX1600C9D3B1/4G , 4Gb , ddr3-1600 , CL9 , 1.7-1.9v - 240pin - lifetime warranty

Product Range Features (Actual Product Features May Differ)

This document describes Kingston's 512M x 64-bit (4GB) DDR3-1600 CL9 SDRAM (Synchronous DRAM), 2Rx8 memory module, based on sixteen 256M x 8-bit FBGA components. This module has been tested to run at DDR3-1600 at a low latency timing of 9-9-9-27 at 1.65V.The SPD is programmed to JEDEC standard latency DDR3-1333 timing of 9-9-9. This 240-pin DIMM uses gold contact fingers. The JEDEC electrical and mechanical specifications are as follows:

*  JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

*  VDDQ = 1.5V (1.425V ~ 1.575V)

*  667MHz fCK for 1333Mb/sec/pin

*  8 independent internal bank

*  Programmable CAS Latency: 9, 8, 7, 6

*  Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

*  Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

*  8-bit pre-fetch

*  Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

*  Bi-directional Differential Data Strobe

*  Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

*  On Die Termination using ODT pin

*  Average Refresh Period 7.8us at lower than TCASE 85°C,3.9us at 85°C < TCASE < 95°C

*  Asynchronous Reset

*  PCB : Height 1.180” (30.00mm), double sided component

Product Range Specifications (Actual Product Specifications May Differ)

*  CL(IDD) 9 cycles
*  Row Cycle Time (tRCmin) 49.5ns (min.)
*  Refresh to Active/Refresh 160ns (min.)
*  Command Time (tRFCmin)
*  Row Active Time (tRASmin) 36ns (min.)
*  Power (Operating) 1.800 W*
*  UL Rating 94 V - 0
*  Operating Temperature 0o C to 85o C
*  Storage Temperature -55o C to +100o C
*  *Power will vary depending on the SDRAM used.